fft_led/avr_adc.c

54 lines
1.6 KiB
C
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

//setup adc for an attiny85
//
#include<avr/io.h>
#include"avr_adc.h"
#define _BS(bit) (1<<bit)
#define _BC(bit) ~(1<<bit)
#define STARTADC ADCSRA |= _BS(ADSC)
//1.setup_prescaler
/* this function initialises the ADC
ADC Prescaler Notes:
--------------------
ADC Prescaler needs to be set so that the ADC input frequency is between 50 - 200kHz.
For more information, see table 17.5 "ADC Prescaler Selections" in
chapter 17.13.2 "ADCSRA ADC Control and Status Register A"
(pages 140 and 141 on the complete ATtiny25/45/85 datasheet, Rev. 2586MAVR07/10)
Valid prescaler values for various clock speeds
Clock Available prescaler values
---------------------------------------
1 MHz 8 (125kHz), 16 (62.5kHz)
4 MHz 32 (125kHz), 64 (62.5kHz)
8 MHz 64 (125kHz), 128 (62.5kHz)
16 MHz 128 (125kHz)
Below example set prescaler to 128 for mcu running at 8MHz
(check the datasheet for the proper bit values to set the prescaler)
*/
void setupADC(void)
{
ADMUX = //_BC(REFS0) | //Set_Vref
//_BC(REFS1) | //Set_Vref
//_BC(MUX3) | //
//_BC(MUX2) | //
// _BS(MUX1) | //
_BS(MUX0) | //PORT Select PB3
_BS(ADLAR); //left shift conversion results(used in 8bit mode)
// ADCSRB = _BS(
ADCSRA = _BS(ADEN) | //Enable ADC
//_BC(ADATE) | //Disable AutoTrigger aka Freerunning mode
// _BS(ADPS1) | //Select Prescaler
_BS(ADPS0) | //prescaler 128
//_BS(ADPS1) |
_BS(ADPS2);
ADCSRA &= ~(1<<ADATE);
}